Fit it yourself

Lay the strips out along the dash and doors to plan the route. Wipe those surfaces clean and dry.

Peel the adhesive backing and press each strip into the gap between trim panels. Use the plastic tool from the installation accessories to push it in neatly.

Tuck the cables behind panels, along door seals and under the seats towards the controller.

Plug the controller into a USB port. Scan the QR code in the box, install the app and pair over Bluetooth. The remote works straight away.

Lay the fibre-optic light guides along the dash, doors and console, and decide where the controller will sit.

Press the light guides into the trim gaps with a plastic trim tool so only the glow shows.

Connect the controller to your car's 12V power exactly as shown in the manual, with the ignition off.

Switch on, pair the app over Bluetooth and test every zone before refitting any panels.

Put the mats in the footwells with the cable end towards the centre console.

Run the cable under the mat edge and along the console to your power socket.

Use the USB plug or the cigarette-lighter adapter, whichever socket you have free.

Pair the app to change colours, brightness and turn on music sync.

Charge the lights with the USB cable before first use.

Wipe the area under the dash or seat where each light will go.

Peel the adhesive and press each light firmly into place, pointing down at the footwell.

Use the remote to turn the lights on and pick a colour or effect.